Lehrstuhl für Fertigungsautomatisierung und Produktionssystematik (FAPS)

Defining Batches under Consideration of Quality-Related Factors for Improved Failure and Scrap Analysis (2018) Baier L, Spindler S, Wacker M, Franke J, Schuderer P Journal article Produktionstechnologien für die Antriebe der Zukunft: Anwendungsorientierte Forschung am E|Drive-Center des Lehrstuhls FAPS in Nürnberg (2018) Kühl A, Mayr A, Masuch M Journal article Substituting bond wires by additively manufactured interconnections (2018) Lomakin K, Sippel M, Gold G, Ringel J, Weiß D, Helmreich K, Ankenbrand M, Franke J Conference contribution Low reflective aerosol Jet printed broadband matched load up to 67 GHz (2018) Lomakin K, Sippel M, Gold G, Fröhlich J, Helmreich K, Ankenbrand M, Franke J Conference contribution Impact of Surface Roughness on 3D printed SLS Horn Antennas (2018) Lomakin K, Pavlenko T, Sippel M, Gold G, Helmreich K, Ankenbrand M, Urban N, Franke A Conference contribution 3D Printed Helix Antenna (2018) Lomakin K, Pavlenko T, Sippel M, Gold G, Weidner T, Helmreich K, Ankenbrand M, Franke J Conference contribution Erzeugung von 3D-Funktionsstrukturen fuer Hochfrequenzanwendungen durch Druckverfahren (2018) Ankenbrand M, Franke J, Lomakin K, Pavlenko T, Sippel M, Gold G, Weidner T, et al. Journal article Numerical and Experimental Investigation of the Velocity Field in Friction Ventilators (2018) Renz A, Praß J, Riedel J, Nadler O, Becker S Conference contribution Evaluation of energy measurements for error detection in press-fitting processes (2018) Sand C, Meiners M, Eberle J, Franke J Book chapter / Article in edited volumes Energy-efficient room ventilation with heat recovery using a novel concept (2018) Praß J, Bürner J, Franke J Journal article